Solving problems with Control Logic before they impact production
Autologic is offering a new Diagnostic and Optimisation Service that applies our Emulate3D software directly to a customer’s PLC code, allowing us to identify, analyse and resolve performance issues in a virtual environment before any changes are made to the live system.
When might you need the service?
The conveyor transfer that occasionally jams but never seems to do it when an engineer is watching. The accumulation zone that backs up without an obvious cause. The system that technically works but never quite reaches its expected throughput. The intermittent fault that operators have learned to work around rather than eliminate.
These issues rarely come down to mechanical equipment alone and are often difficult, expensive or risky to diagnose on a live production system. More often, the root cause lies deep within the control logic that drives the system and triggered only under specific operating conditions or caused by interactions between multiple sections of the system.
By connecting an Emulate3D model directly to an offline instance of a PLC program, we can replicate these issues in a safe virtual environment and trace them back to their exact source.
What can it find?
Typical findings can include:
- Sequencing errors that create unnecessary delays between operations.
- Logic conditions that cause conveyors to accumulate product prematurely.
- Transfer timing issues that lead to recurring jams or blockages.
- Recovery routines that do not operate as intended.
- Conflicting logic controlling the same equipment.
- Legacy code that continues to influence system behaviour.
- Parameters that restrict performance without operators realising.
Many of these issues are not obvious during normal operation. They may only reduce throughput by a few percentage points or create occasional interruptions, but over time they can have a significant impact on productivity, maintenance effort and Overall Equipment Effectiveness (OEE).
A safe way to troubleshoot
Making changes to a live production system is risky. Testing potential fixes can require planned downtime with uncertainty about the outcome. Our new Diagnostic and Optimisation Service removes that risk.
Using the emulation model, we can reproduce faults, trial potential solutions and validate results before any changes are deployed to the real facility.
Engineers can test modifications, run the model repeatedly, measure performance improvements and compare alternatives all without disrupting production.
We can find improvements too
While the capability is highly effective for troubleshooting known issues, it is equally valuable as a performance improvement tool.
Many facilities are operating reliably but not optimally. Small inefficiencies within the control logic can accumulate across an entire system: limiting throughput; increasing congestion; and creating unnecessary operational constraints.
By analysing the interaction between the PLC code and a virtual representation of the system, we can identify cost-effective opportunities to improve flow, reduce bottlenecks and increase performance.
To book a 30 minute discovery call email andy.parsons@autologic-systems.co.uk.

